We are about to do our ensuite and are looking for feedback about showers without doors

[Guest]

Hubby is worried about water getting out of the space. We will have a tiled base and 100cm glass wall.

[Debra]

The toilet doesn't get wet. The room is 2.4 wide, the shower space .9 x 1

[Dan]

The code now is where the water comes out the wall should be contained in a 1.5m arc. So the fall should start 1.5m out.

People used to just agree to squeegee any water/mist that made it out but we aren't supposed to allow it now. Ours is 1.3 and still get mist out.

That's showerhead opposite entry.

Don't miss: Has anyone went with frameless showers?

[Grace]

Our glass is only 800 wide and yes, a little bit of water splashes out of the opening, and spreads about fifteen cms out on the floor.

I just have a bathmat there and it's fine.

It's honestly just some drops of water, not any more than that.

[Jessica]

We have a tiled base with a screen 90cm and we don’t get water out past the glass.

[Carly]

Our glass is 1100, we went from an enclosed shower to this, and I was worried with 2 kids that we would have water everywhere.

No issues at all, a little bit of mist past the glass within the shower area.



Explore these too: I am looking to see if anyone has photos of a large shower with a 100mm-ish step up

[Matt]

I have fallen the wet area forward with the drain at the entry of the shower.

This has shown in tile application studies to be the best capture of water.

[Shonelle]

Our glass panel is 1100mm long and splashes do extend past that point.

It doesn’t worry us as they are minor and it’s contained within the wet room side.

[Kat]

Our shower width is 1200mm instead of usual 900mm. I find that with 900mm glass no water escapes with entry.

If have room make shower wider honestly.